Jump to content

Slow Seedling Growth Advice Needed


Slartibarfast
 Share

Recommended Posts

Hi, I am growing Fast Buds C4. The seed sprouted in soil 11 days ago and the growth seems to be a bit slow. I am using a 3500k 240W quantum board at 60CM from the plant at around 80W. Does this look normal and are there any suggestions as to what I can do to help it speed up? Growing in coco and just been giving it plain water so far. I am tempted to just switch back to my blurple LED light just to help get it into a good veg space.

1634539779552.png

  • Like 1
Link to comment
Share on other sites

I was just about to say, that seedling looks a little light green, they don't really take up any nutes at this time so defs count deficiency out, only other reason a plant would turn that colour is over water. 

to pop a seed they need 100% saturation for about 24hrs, so either leaving them in a glass of water or put them in completely saturated soil, from there you need to slowly decrease the amount of water around the seed only making sure to not let the medium dry completely. so you let the medium go to 30% moisture or pick up the pot, it should be light before giving any water again and when you do just give a tiny amount about 2cm away from the base of the seedling. make the roots go looking for the water. don't saturate the medium again untill the seedling has formed a complete rootball. 

note that if you're in a bigger pot it'll take longer to dry out so you need to water much less. 

  • Like 1
Link to comment
Share on other sites

I don't think your light is the issue, you said you're growing in coco? Your own mix?
Using Atami High Porosity Cocos. Thanks for all the advice, I will hold off watering any further and see how it goes. I also feel it's too early for nutes, I may introduce at the end of the week maybe.

Sent from my SM-N950F using Tapatalk

  • Like 1
Link to comment
Share on other sites

So when I pot clones or pop seeds (just did some seeds yesterday).

I saturate my medium with 2L to 3L of full strength veg nutes (GHE tripart), that is in a 20L fabric pot. Never had any issues with stunted growth and the medium stays moist for around a week as it mostly evaporates over time as they don't drink much.

Even if the medium is still a bit wet after a week, I will give a bit of feed as well but not the full 3L per pot. My grow environment is likely different to yours though - RH, temp, air flow etc.

 

I always feed with nutes though, you have your 2nd set of true leaves there as well. Never tried to get seedlings going in coco without nutes, but never had issues either. Not saying it is needed as I know seedlings can go without nutes for upto 3 weeks, just easier for me and I make sure to PH obviously. It does not do any harm. The nutes are then available for when the seedling is ready.

Auto's can be iffy at times though, the most issues I have experienced have been with auto's. Pop multiple seeds at once, some have amazing growth and out of say 5 one is just super slow. Never had this with photoperiods and I have popped a lot more photo seeds.

 

I really doubt it is your light. You could lower it a little if you really wanted to but I don't feel that is necessary.

  • Like 1
Link to comment
Share on other sites

3 minutes ago, PsyCLown said:

Auto's can be iffy at times though, the most issues I have experienced have been with auto's. Pop multiple seeds at once, some have amazing growth and out of say 5 one is just super slow. Never had this with photoperiods and I have popped a lot more photo seeds.

I am going through with this now with some autos I've popped recently 🙄

  • Like 2
Link to comment
Share on other sites

I'm using a 240W LED for the first time, coming from HPS. Popped a few seeds a couple of weeks ago and the growth was terribly slow even at 130W. With HPS I would try to maintain the ambient temperature at 26 degrees. I've since raised the ambient temperature in my box to 29 degrees in an attempt to get the leaf surface temperature a bit higher, this seemed to work for me. I am not sure what your temps are, but this could also be a contributing factor. 

  • Like 1
Link to comment
Share on other sites

  • 1 month later...
I'm using a 240W LED for the first time, coming from HPS. Popped a few seeds a couple of weeks ago and the growth was terribly slow even at 130W. With HPS I would try to maintain the ambient temperature at 26 degrees. I've since raised the ambient temperature in my box to 29 degrees in an attempt to get the leaf surface temperature a bit higher, this seemed to work for me. I am not sure what your temps are, but this could also be a contributing factor. 
You might be correct, the temps were quite low around then. Anyway things never improved and I started a new grow, things are still a bit slow but way better than the grow on this discussion

Sent from my SM-N950F using Tapatalk

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...